INNOVA 3030A OWNER'S MANUAL Pdf Download (2024)

FAQs

How to reset innova code reader? ›

RED LED - Indicates there is a problem in one or more of the vehicle's systems. The red LED is also used to show that DTC(s) are present. DTCs are shown on the Scan Tool's display. In this case, the Malfunction Indicator (“Check Engine”) lamp on the vehicle's instrument panel will light steady on.

YELLOW LED - Indicates there is a possible problem. A “Pending” DTC is present and/or some of the vehicle's emission monitors have not run their diagnostic testing.

The only way to clear a PDTC is to fix the underlying problem with the vehicle that originally caused the PDTC and its corresponding DTC to set, and then allow the vehicle sufficient drive time to re-run the monitor that identified the problem in the first place.

Monitor Status – If the code reader's LCD display shows the message 0 DTC (indicating there are no DTCs present in the vehicle's computer), but the yellow LED is lit, it indicates a Monitor Has Not Run status. This means that some of the monitors on the vehicle have not yet finished their diagnostic self-testing.

A "Hot Key" is considered to be any button on the diagnostic tool. Innova Electronics, Corp.

DTC stands for Diagnostic Trouble Code.

If your Check Engine light becomes illuminated, for example, this could signal any of several emissions-related faults your system has detected, such a problem with your fuel system or evaporative emissions controls.

0 – A zero means the code is generic and applicable to all vehicles following the SAE OBD-II international standard. In fleet management, this encompasses the vast majority of vehicles. 1 – This denotes a manufacturer-specific code, which is not generic across all vehicles.

There are four different types of OBD-II codes – P, B, C, and U. The P stands for powertrain (engine and transmission) systems, B for body, C for chassis, and U for network and wiring systems.

Open app on your computer. Plug your OBD2 scanner to your computer. If an update is available a button will appear "Update my tool now". Click the button to begin update process.

What is mode 6 on a scanner? ›

Mode 6 can be thought of as a 'crystal ball' for check engine lights. If components start failing or performing below standards, the test results in mode 6 will reflect the fact that the component's test is failing before the check engine light even comes on.

1. I/M MONITOR STATUS- Identifies the I/M Monitor status area. 2. Monitor icons - These icons indicate which Monitors are supported by the vehicle under test, and whether or not the associated Monitor has run its diagnostic testing (Monitor status).

Plug an OBD-II scanner into your vehicle's OBD port and reset it to clear the check engine light. Disconnecting and reconnecting your battery will restart your vehicle's computer and clear the light. Drive an older vehicle around for a few days after repairs. The light will go off on its own once the computer resets.